流於兩側閉口端部封閉管道入口，紊j炭產生器置於管道入口，流場雷諾數為1500 及15000 。實驗內容主要為管道斷函、邊界層內三維向穩態及非穩態速度量測。研究結果顯示，管道中央斷面流場有一般銜擊流特性;而靠
近管道壁面之流鐘，受到底板所造成逆向壓力及壁面摩擦力雙重影響，導致逆向流產生;雷諾數小，軸向動能較小，因此雷諾數的00 時，其逆向it較雷諾數15000 提早發生。紊流產生器之影響，造成更大區域之逆向流以
The study experimentally investigates the turbulator effects on flow characteristics in a side-open, end-sealed duct, which simulates the cooling passages in the fin-type heat sinks of electronic equipments. Specifically, this research investigates the effects of fluid side-leakage and turbulator on the flow structures and near-wall flow characteristics, such as the convective mean velocity, the secondary flow and the turbulent kinetic energy. A windtunnel system is used to generate a unifonn flow at the inlet of the side-open, end-sealed duct. A delta-wing turbulator is placed at the inlet of the duct for the turbulator-effect study. The Reynolds numbers are 1500 and 15000. The measurements include three-component mean and fluctuating velocities at duct cross-sections and near the duct wall. Results of this study indicate that the flow in the central plane of the duct is similar to an impinging flow. Due to the reverse pressure by the end wall and the friction force by the duct wall, the flow reversal occurs near the duct wall. The reversal flow occurs earlier for smaller Reynolds number than that for larger Reynolds because of the smaller flow kinetic energy. The effects of the turbulator causes lager dead water flow region and, thus, results in worse convective effect. However, the turbulator causes the larger secondary velocity and turbulent kinetic energy and, thus, results in better secondary and turbulent effects on the near-wall flow characteristics.