| Single-Point Diamond Turning of Plasma-Nitrided Stainless Steel | |
|---|---|
| 學年 | 96 |
| 學期 | 1 |
| 出版（發表）日期 | 2007-12-01 |
| 作品名稱 | Single-Point Diamond Turning of Plasma-Nitrided Stainless Steel |
| 作品名稱（其他語言） | |
| 著者 | Chao, Choung-Lii; Chen, Chun-Chieh; Chang, Chia-Jong; Dong,Hanshan; Ma, Kung-Jeng; Hsu, Wei-Yao; Huang, Kuo-Cheng; Chao, Chung-Woei |
| 單位 | 淡江大學機械與機電工程學系 |
| 出版者 | Stafa-Zurich: Trans Tech Publications Ltd. |
| 著錄名稱、卷期、頁數 | Key Engineering Materials 364-366, pp.601-606 |
| 摘要 | Stainless steel and other ferrous metals are normally classified as not diamond turnable for the unacceptable tool wear caused by the thermal-chemical reaction between diamond and ferrous metals. In the present research, stainless steel specimens were plasma nitrided at a relatively low temperature (<450oC) to prevent the depletion of Cr content at the austenite matrix and to give a hardened layer where Fe atoms are bonded to nitrogen atom to form γ’-Fe4N. Diamond turning experiments were subsequently carried out under the following machining conditions: single crystal diamond tool, cutting speed up to 180 m/min, cut depth up to 5μm and light mineral oil as the cutting fluid. The results showed that, given the same machining conditions, while rapid tool wear and poor surface finish were obtained when turning the as-received stainless steel, surfaces with Ra better than 3nm and no obvious tool wear were achieved when turning the plasma nitrided specimens |
| 關鍵字 | Plasma Nitriding;Single Point Diamond Turning;Stainless Steel;Surface Roughness (SR);Tool Wear |
| 語言 | en |
| ISSN | 1013-9826 1662-9795 |
| 期刊性質 | 國外 |
| 收錄於 | SCI EI |
| 產學合作 | |
| 通訊作者 | Chao, Choung-Lii |
| 審稿制度 | |
| 國別 | CHE |
| 公開徵稿 | |
| 出版型式 | 紙本 |
| 相關連結 |
機構典藏連結 ( http://tkuir.lib.tku.edu.tw:8080/dspace/handle/987654321/65382 ) |
| SDGS | 產業創新與基礎設施 |
GoogleAnalytics