期刊論文
| 學年 | 86 |
|---|---|
| 學期 | 1 |
| 出版（發表）日期 | 1997-09-01 |
| 作品名稱 | Measurement of elongational viscosity for polymer melts by fiber spinning |
| 作品名稱（其他語言） | |
| 著者 | Lin, Gwo-geng; Hu, Ming-chong |
| 單位 | 淡江大學化學工程與材料工程學系 |
| 出版者 | Hoboken: John Wiley & Sons, Inc. |
| 著錄名稱、卷期、頁數 | Advances in Polymer Technology 16(3), pp.199-207 |
| 摘要 | The elongation behavior of various polymer melts extruded from the single screw extruder has been studied. Low-density polyethylene, high-density polyethylene, polypropylene, and their short glass-fiber (GF)-filled composites were used. It was found that the spinning stability was good but the drawability was poor for GF-filled polymers. The elongation viscosity was measured by use of a Gottfert tensiometer (Rheotens) in the strain rate range from 0.1 to 4 s−1. In regard to the viscosity calculations, a very convenient and straightforward method, especially for molten materials without die swell, is presented. All the sample melts showed slight tension thinning; that is, the elongation viscosity decreased along with the strain rate. It was also found that the elongation viscosity of the GF-filled polymer may increase along with the fiber content up to a critical value, and then drop if more fiber is added. The influence of the die geometry on the viscosity measurement is discussed. |
| 關鍵字 | |
| 語言 | en |
| ISSN | 0730-6679 |
| 期刊性質 | 國外 |
| 收錄於 | |
| 產學合作 | |
| 通訊作者 | |
| 審稿制度 | |
| 國別 | USA |
| 公開徵稿 | |
| 出版型式 | 紙本 |
| 相關連結 |
機構典藏連結 ( http://tkuir.lib.tku.edu.tw:8080/dspace/handle/987654321/71271 ) |