期刊論文

標題 Single-Point Diamond Turning of Plasma-Nitrided Stainless Steel
學年 96
學期 1
出版(發表)日期 2007/12/01
作品名稱 Single-Point Diamond Turning of Plasma-Nitrided Stainless Steel
作品名稱(其他語言)
著者 Chao, Choung-Lii; Chen, Chun-Chieh; Chang, Chia-Jong; Dong,Hanshan; Ma, Kung-Jeng; Hsu, Wei-Yao; Huang, Kuo-Cheng; Chao, Chung-Woei
單位 淡江大學機械與機電工程學系
出版者 Stafa-Zurich: Trans Tech Publications Ltd.
著錄名稱、卷期、頁數 Key Engineering Materials 364-366, pp.601-606
摘要 Stainless steel and other ferrous metals are normally classified as not diamond turnable for the unacceptable tool wear caused by the thermal-chemical reaction between diamond and ferrous metals. In the present research, stainless steel specimens were plasma nitrided at a relatively low temperature (<450oC) to prevent the depletion of Cr content at the austenite matrix and to give a hardened layer where Fe atoms are bonded to nitrogen atom to form γ’-Fe4N. Diamond turning experiments were subsequently carried out under the following machining conditions: single crystal diamond tool, cutting speed up to 180 m/min, cut depth up to 5μm and light mineral oil as the cutting fluid. The results showed that, given the same machining conditions, while rapid tool wear and poor surface finish were obtained when turning the as-received stainless steel, surfaces with Ra better than 3nm and no obvious tool wear were achieved when turning the plasma nitrided specimens
關鍵字 Plasma Nitriding;Single Point Diamond Turning;Stainless Steel;Surface Roughness (SR);Tool Wear
語言 英文
ISSN 1013-9826;1662-9795
期刊性質 國外
收錄於 SCI;EI
產學合作
通訊作者 Chao, Choung-Lii
審稿制度
國別 瑞士
公開徵稿
出版型式 紙本